Connect And Disconnect - TRENDnet TBW-107UB User Manual

2. Bluetooth devices within the radio range will be shown around the center
ball.
3. Wait for a few seconds until the names of all the devices are obtained.
Add Device from History List
The devices which had been found or connected can be added from the history
device list directly.
1. Select menu Tools | Add Device from History.... The History dialog box pops
up.
2. Select the device from the list and click button Add, the device will be added
to the main window.
Add a New Device by Entering Device Address
If the device cannot be found by Inquiring, you can enter the device address to add
the device.
1. Select menu Tools | Add New Device.... The Add New Device dialog pops up.
2. Enter the Bluetooth device address and click button OK, the device will be
added to the main window.
Note: The device type will be unknown if add it by inputting its Bluetooth address.
Connect and Disconnect
Connect
1. Select a remote device and double click it to browse its services.
Bluetooth passkey may be asked if security level of either side is set to high
and they are not paired devices.
After service browsing, the services the remote device supports are
highlighted by changing the color of the service buttons on the top of the
main window.
2. Single click one of the service button to connect.
After connection is setup, the remote device and the service button will turn
green.