Device Usage; Replacing Accessories; Waste Disposal - HOGERT HT2E100 User Manual

WORKPLACE
To ensure safety at work, adequate lighting must be provided and the workplace must be kept clean. Do not use the device in an
environment with an increased risk of explosion, or in an environment of flammable liquids, gases or vapours. Use appropriate perso-
nal protective equipment during work and avoid work in a state of fatigue. Ensure that the workplace is adequately ventilated to prevent
the inhalation of harmful fumes generated during work.

DEVICE USAGE

Before starting work, make sure that the unit is free from defects and faults, that the power cord is not damaged or interrupted. If any
malfunction is detected, do not continue working and return the unit to an authorized service center. Make sure that the plug of the
electric cable fits into the mains socket. Avoid contact between the power cable and heat, oils, sharp edges and moving parts. Damage
to the power cord increases the risk of electric shock. Use the right tool for the job and avoid overloading it. Before starting work, the
workstation must be properly prepared. Make sure that the „ON/OFF" switch is in the „OFF" position. Then, while holding the grinder
by the handle, insert the plug into the electrical socket. Then turn the speed control knob in the direction of the smallest digit, reducing
the speed. You can then switch the power button to the „ON" position. If necessary, the speed can be increased by moving the speed
control knob towards the larger figures. When the work is finished, reduce the speed by moving the speed control knob towards the
smallest digit. Then you can turn the grinder off by switching the power button to the „OFF" position. Wait until the grinder stops
completely. Unplug the power plug from the electrical outlet. Then you can start cleaning and maintaining the device. Do not exert too
much pressure on the workpiece or make sudden movements during operation so as not to damage the attached equipment or the
device itself. CAUTION: The unit heats up during operation and as the temperature of the unit rises, take breaks to cool it down. Do not
immerse the device in water or other liquids to cool down. Do not machine any live parts with the grinder.

REPLACING ACCESSORIES

To install/replace accessories, switch the grinder off by switching the clamping button to the „OFF" position and unplug it from the
electrical socket. Then press the lock button with one hand and unscrew the nut of the drill chuck to the memorial with the other hand
until the accessories can be installed. Then slide it into the handle and tighten it back with the wrench, also by pressing the lock button
with the other hand. When you have finished installing the accessories, make sure they are installed correctly and firmly.
MAINTENANCE, SERVICE, CLEANING
Always unplug the device from the mains socket before performing maintenance and cleaning. Use a dry, soft cloth or brush to remove
the dirt. Do not use cleaning agents or solvents. An air stream of not more than 0,3 MPa may also be used. To ensure smooth operation,
the spindle should be periodically oiled.

WASTE DISPOSAL

Damaged equipment, accessories and packaging materials should be recycled and used in an environmentally friendly manner.
4
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków