Bosch WAT28400TC Use And Care Manual page 32

Clean the strainers at the water tap end of the hose
Remove the hose from the tap.
1.
Rinse the strainer under running water. Look at the
2.
strainer to see if any visible debris is still present.
Rinse again if necessary to remove the debris.
Reconnect the hose to the tap.
3.
Clean the strainers at the washer end of the hose
Remove the hose from the inlet on the back of the
1.
washer.
Using narrow pliers, grasp and pull the strainer from
2.
the inlet port.
Rinse the strainer under running water.
3.
Reconnect the hose to the back of the washer and
4.
turn on the water tap. Check to see if water flows by
starting a warm water wash cycle.
NOTICE: Check for leaks to be sure the rubber washers
are seated at both ends of the water supply hose and the
connections are properly tightened.
32