Specifications - SimpliSafe CA002 Owner's Manual

(9) SPECIFICATIONS

If the Smoke/CO Detector is defective in any way, do not tamper with the
unit. Contact SimpliSafe at 1-888-910-1215
Power Source:
Required batteries
Smoke Sensor
CO Sensor
Audible alarm
Sensitivity
Dimensions
Weight
Operating Temperature
Operating Relative
humidity
CO Alarm response times
Agency Listings
31
2x Panasonic CR123A 3V
lithium battery
Photoelectric 1.60 to 2.60 %/
ft obscuration sensitivity
Electrochemical
Over 85dB at 3m temporal pattern
Per UL217 and UL 2034
12cm diameter x 4.5cm
0.6 lbs
40 to 100°F (4.4 to 37.8°C)
10 to 95% non-condensing
70 PPM = 60-240 min.
150 PPM = 10-50 min.
400 PPM = 4-15 min.
UL 217 8th (ETL Listed)
UL 2034 4th (ETL Listed)
FCC Part 15 Notice
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful inter-
ference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help