Battery Installation; Pairing To The Base Station - SimpliSafe CA002 Owner's Manual

Mounting
Bracket
WARNING: Do not connect the Smoke/CO Detector to any other alarm or
auxiliary device. Connecting anything else to this detector will keep it from
working properly.
CAUTION: This Smoke/CO Detector comes with cover latches that will
prevent the Smoke/CO Detector cover from closing if the batteries are not
installed. This tells you that the Smoke/CO Detector will not work until a new
battery is properly installed.
D. Battery Installation
(1) Open the battery compartment
(2) Install two CR123A 3V lithium batteries, making sure the + and - ends of
the battery are aligned properly.
15
(3) After the batteries are installed and the Smoke/CO Detector is mounted
on its bracket, you will see the green LED flash.
NOTE: Use only Panasonic or Duracell CR123A batteries. This Smoke/CO
detector may not operate properly with other kinds of batteries.
E. Pairing to the Base Station
Test / Silence
Button
This section describes the basic steps for pairing the Smoke/CO Detector to
the Base Station.
(1) Go to the Menu on the keypad and select "Setup and Naming"
(2) Press the Test Button on the Smoke/CO Detector.
(3) Name the Smoke/CO Detector on the keypad.
(4) Press "Done" to exit pairing.
F. Verify Pairing and RF Communication Between Smoke/CO Detector and
Base Station
To determine a strong communication path with the Base Station, this
verification test should be performed in accordance with NFPA 72 inspection,
testing and maintenance requirements found in Section 8(A) of this Manual.
(1) Go to the Menu on the keypad and select "Test Mode"
(2) Press the Smoke/CO Detector Test Button for 1 second.
(3) The Smoke/CO Detector will beep once and the Base Station will
announce the Smoke/CO Detector.
16