Product Diagram; Remote Control; Structure And Interfaces; Installing & Replacing The Battery - Braun DigiFrame 80 Instruction Manual

8

1 Product Diagram

1.1 Remote Control

1. POWER_ Switch On/Off
2. SETUP _Enter copy & delete interface.
3. Rotate _In the pause status of single picture,
press ROTATE to revolve the picture 90° in
counterclockwise each time.
4. _ Functional selection button - top cursor.
5. Zoom_In the pause status of single picture,
magnify picture display size.
6. _ Functional selection button - left cursor
7. OK_ Press to confirm. Play/pause: In single pic-
ture mode, press it to start slideshow; In slides-
how mode, Press it to pause, then repress it to
play.
8. _ Functional selection button - right cursor
9. SLIDE SHOW_ Press to start slideshow directly
10. _ Functional selection button - bottom cursor.
11. EXIT _ Press to return to upper page, or enter
the main menu
E N G L I S H

1.2 Structure and Interfaces

Left side:
1 Card slot:
SD/SDHC, MMC
2 USB port
3 DC in:
5V/1A
Rear side buttons:
1 POWER on/off (long press)
2 Up
3 Play / Pause /OK
4 Right / Forward / Next
5 Left / Back / Previous
6 Down
7 Menu / Exit (short press)
2. Installing & Replacing the Battery
Place the upside of the remote control down, press
down on the ridged area of the battery cover and
pull towards you to remove the tray. Place one
CR2025 lithium button-cell battery on the tray with
the positive "+"side facing you. Reinsert the tray.