Sanyo LCD-40R40HD Service Manual page 10

adjustment" of factory menu and select item "AUTO COLOR", system will begin calibration
automatically,
Press key "Menu" to be back to upper menu, set "Program source" as VGA", input monochrome
signal with format of 800×600/60 Hz (VG848: Timing is 854，PAT is 948), enter into submenu "ADC
adjustment" of factory menu and select item "AUTO COLOR", system will begin calibration
automatically,
4.2.6.2 White balance adjustment (models except LC-19KC72, LC-22KC72)
TV set should be working for above 30 minutes to be in stabler state before white balance
adjustment; connect CA210 to USB port of PC with data line; connect VG848 and TV to COM port of
PC or virtual COM port respectively (default connection: VG848 to COM5,TV to COM1, the
connection can be altered and saved in administrator window with password "xoceco" if necessary);
output signal of VG848 must be sent to AV, YPbPr, VGA and HDMI1 channels of TV;
Open program file "White_Balance.exe", load configure file "AdjustConfig.txt", then connect
CA210, VG848 and TV respectively according to the instruction on interface.
Note: set probe to "0-CAL" before connecting CA210, press "connect CA210", set probe back to
"MEAS" after prompt "CA-210 connection and calibration are normal !" appears on the left-down side;
BBY channel is used by CA210 for BBY models, for other models, channels except BBY are used by
CA210; please enter into administer window with password "xoceco" to alter and save apparatus
setting if it is different;
At last, press "Begin auto-white-balance-adjustment", auto-adjustment will be completed until
prompt "Adjustment is successful" appears.
4.2.6.3 White balance adjustment (models except LC-19KC72, LC-22KC72)
TV set should be working for above 30 minutes to be in stabler state before white balance
adjustment; connect CA210 to USB port of PC with data line; connect VG848 and TV to COM port of
PC or virtual COM port respectively (default connection: VG848 to COM5,TV to COM1, the
connection can be altered and saved in administrator window with password "xoceco" if necessary);
output signal of VG848 must be sent to AV, YPbPr, VGA and HDMI1 channels of TV;
Note: Channel shared by AV/YPBPR must be adjusted respectively.
Open program file "White_Balance.exe", if current working progress includes AV channel, enter
into channel setting of administer window to make sure no YPBPR576i@60 but AV is chosen, or load
configure file "AdjustConfigAV.txt"; if current working progress includes YPBPR channel, enter into
channel setting of administer window to make sure no AV but YPBPR576i@60 is chosen, or load
configure file "AdjustConfigYPBPR.txt.txt"; then connect CA210, VG848 and TV respectively
according to the instruction on interface.
Note: set probe to "0-CAL" before connecting CA210, press "connect CA210", set probe back to
"MEAS" after prompt "CA-210 connection and calibration are normal !" appears on the left-down side;
BBY channel is used by CA210 for BBY models, for other models, channels except BBY are used by
CA210; please enter into administer window with password "xoceco" to alter and save apparatus
setting if it is different;
At last, press "Begin auto-white-balance-adjustment", auto-adjustment will be completed until
prompt "Adjustment is successful" appears.