Table of Contents
Advertisement
Appendix: Stand Assembly/Disassembly
If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend
to mount your TV on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not
sure of your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional
installer or service personnel. The manufacturer is not responsible for any damages or injuries that occur due to
mishandling or improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent
accidental scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This
can cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Push downwards
Stand groove
Adjusting the viewing angle
Backward
Forward
To install the stand:
Place the stand on the table, hold the display upright and
aim the bottom stand column toward the stand groove,
then carefully push the display downwards, fully insert
the column into the stand until the lock snaps. Now the
stand is assembled.
Stand column
Stand
To adjust the viewing angle:
! You can tilt the screen forward or backward.
Caution: When adjusting the viewing angle, be careful not to
tip over your TV.
39
Advertisement
Table of Contents
