Table of Contents
Advertisement
en Installation instructions
17.6 Instructions for the exhaust air pipe
The appliance manufacturer does not provide any war-
ranty for faults attributable to the pipeline.
¡ Use a short, straight exhaust air pipe with as large a
pipe diameter as possible.
¡ Long, rough exhaust air pipes, many pipe bends or
small pipe diameters reduce the suction power and
increase the fan noise.
¡ Use an exhaust pipe that is made of non-combust-
ible material.
¡ To prevent condensate from returning, fit the ex-
haust pipe with a 1° gradient from the appliance.
Note: Suitable air extraction ducts are available from
our after-sales service, your dealer or on our website.
Flat ducts
Use flat ducts with an inner cross-section that corres-
ponds to the diameter of the round pipes:
¡ Diameter of 150 mm corresponds to ap-
prox. 177 cm².
¡ Diameter of 120 mm corresponds to ap-
prox. 113 cm².
¡ Use sealing strips for different pipe diameters.
¡ Do not use any flat ducts with sharp bends.
Round pipes
Use round pipes with an inner diameter of 150 mm (re-
commended) or at least 120 mm.
17.7 Installation
Checking the units
Check whether the fitted unit is level and has suffi-
▶
cient load-bearing capacity.
The maximum weight of the appliance is 40 kg.
Preparing the units
Note: To install the hob and the appliance seamlessly,
you require special accessories, which are not included
in the scope of delivery. Observe the enclosed installa-
tion instructions for special accessories.
Requirement: The unit is suitable for the installation.
20
Make a cut-out in the worktop, depending on the in-
1.
stallation position.
The angle between the cut surface and the worktop
must be 90°.
Ensure that the worktop has sufficient load-bearing
2.
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
Ensure that the fitted unit is still stable after the cut-
3.
outs have been made.
Remove any shavings.
4.
Depending on the installation position, remove the
5.
back panel of the fitted unit.
Preparing the appliance
WARNING ‒ Risk of injury!
The appliance is heavy.
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
▶
Place the appliance on a soft surface and remove
1.
the transit bolt.
Stick the seal in the designated groove
2.
it .
and trim
Advertisement
Table of Contents
