Madison MAD-RETROCASE-CR User Manual page 3

Headphone Jack
Plug headphone into the headphone jack to listen to the music. Headphone is not included with the unit.
Note: When using headphone, the sound from the speaker will be cut off
RCA Audio Out
Play back your turntable music through external speakers. To make this connection, you need an RCA cable.
Play 45rpm Vinyl
Place the 45 rpm ADAPTOR over the spindle. Gently place your 45rpm record onto the turntable. Follow the steps
under Turntable operation to play your record.
USB/SD Control
This function part allows the user to play music from the inserted USB flash drive, SD card, Bluetooth or Aux source.
Insert a USB/SD media.
MODE: Short press to select among USB/SD, BT, and recording FILE stored in USB/SD
: play previous music
: play next music
in play mode: short press to start or pause playing. Long press
to delete the current music recorded from an external sound
source. In record mode, press to stop recording.
RECORDING A VINYLE ON USB/SD
When playing an old vinyl, keep the MODE button pressed for about 3 seconds. The recording will start and the
GREEN light is flashing until you press the
BT CONTROL
When the tone arm is set to rest position, the Bluetooth function will start automatically. Press the mode button to
cycle between USB/SD and BT.
Replacing the Stylus Cartridge
Refer to figures 1-8
1. Push the arm lock to release the tone arm.
2. Take off the cap of the cartridge to access the needle.
3. Separate slightly the cartridge from the socket.
4. Unplug the audio wire from the cartridge.
To fit a new cartridge, repeat process 3 & 4 in reverse order.
©Copyright LOTRONIC 2017
key to stop it.
MAD-RETROCASE 3