Advertisement
Quick Links
06/2023
Cedar Mini Pod Sauna
Assembly Instructions
Requirements:
2 People (recommended)
* Carpenter's Hammer
* Step Ladder
* Cordless Drill (we supply the bit)
* Tape Measure
Carpenter's Level
•
Rubber Mallet
It is highly recommended to view the assembly video prior to starting assembly!
View the assembly process
tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com
Advertisement
Related Manuals for leisurecraft Mini Pod
Summary of Contents for leisurecraft Mini Pod
- Page 1 * Step Ladder * Cordless Drill (we supply the bit) * Tape Measure Carpenter’s Level • Rubber Mallet It is highly recommended to view the assembly video prior to starting assembly! View the assembly process tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 2 Bevel Siding Installation Back Wall L-Bench Installation Side Wall Bench Installation Porch Bench Installation Electric Heater Installation (Option) Harvia M3 Wood Heater Installation (Chimney out the back wall) (Option) Vent Installation Care & Maintenance Warranty tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 3 A solid base for your sauna is recommended and can be made from any of the following. Concrete Pad Wood Deck Crushed Stone Patio Stone/Paver Blocks It is recommended to build a base larger than required to provide a sitting area for cooling off during your sauna session tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 4 Cedar Mini Pod Sauna Assembly Instructions Sauna Assembly Start the assembly of your Mini Pod Sauna by laying out the front and back base plates and the side base supports. Ensure the grooves are facing upwards. Secure the 4 mitered corners together using 3 – 2 ½”...
- Page 5 Secure the last floorboard into all of the supports. Measure the remaining gap and cut the last floor piece to fit. Secure it to all of the supports. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 6 (if applicable) Ensure the front panel is centered and then secure the front panel on the side with the wall stave using 2 – 3” (76mm) screws. Repeat for changeroom wall (if applicable) tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 7 Place a side front wall section on top of the front bottom section. Ensure the panel is flush to the edge of the bottom piece and secure with a 2 ½” (64mm) screw on each end. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 8 2 ½” (64mm) screw at each end. Place the middle rear wall panel onto the rear bottom panel ensuring the ends are flush and secure with a 2 ½” (64mm) screw on each end. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 9 2 ½” (64mm) screw at each end. Repeat for the rear top section. Locate the top roof staves. These will have an angle cut on one side and rounded on the other. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 10 You may need to tap them with a rubber mallet to get them tight together. Continue installing the staves working towards the bottom. When you get to the temporary wall staves, remove them then secure them into the correct position. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 11 Lastly, place 5 – 2 ½” (64mm) screws into the door frame to secure to the front wall. On the side with the hinges, place the screw into the middle hole of the hinge. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 12 When you get to the top of the sauna, place the last strip so it overlaps the top piece on each side. Overlap the membrane on the front and back and secure it with staples. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 13 Line up the next piece of trim and secure in the same manner as the previous step. Continue this process to the bottom of the sauna on both sides. Repeat at the other end of the sauna. Locate the spacer for the bevel siding. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 14 When you reach the top, center the top piece of bevel siding and secure with staples. Add more staples to all the bevel siding pieces if your sauna is located in an area prone to heavier winds. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 15 Attach the side wall bench to the back wall bench from underneath by first ensuring they are flush on the top and then securing with 2 ½” (64mm) screws. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 16 Square up the supports and secure to the floor with 2 ½” (64mm) screws. Position Back rest in groove on bench. If desired, use 2 ½” (64mm) screws in between slats to secure the back rest to the walls. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 17 Position Back rest in groove on bench. If desired, use 2 ½” (64mm) screws in between slats to secure the back rest to the walls. Repeat process for opposite side bench and changeroom benches. (if applicable) tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 18 Secure the porch seat to the front wall from underneath using (3) - 2 ½” (64mm) screws in the predrilled holes. Secure Bench leg to floor with 3” (76mm) screws. Repeat for porch bench on opposite side. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 19 Secure the porch seat to the front wall from underneath using (3) - 2 ½” (64mm) screws in the predrilled holes. Secure Bench leg to floor with 3” (76mm) screws. Repeat for porch bench on opposite side. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
-
Page 20: Electric Heater Installation
(2) – 1 ½” (38mm) screws per side. Repeat for the bottom heater guard support. Place 2- 2 ½” (64mm) screws into the pre-drilled holes on either side of heater guard to prepare for mounting. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com... - Page 21 This is recommended to burn off any oils impurities from manufacturing, and it also “cures” the woodwork. All wiring should be installed according to the heater manufacturers instructions and by a • licensed electrician. • Do NOT use a G.F.I breaker tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 22 Fasten the stove handle onto the stove door With the screws provided. Remove the screw on the back of stove and remove the back flap. Place the heat shield on the floor where the stove will tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 23 Place the short metal pipe into the back of the stove and mark it where it meets the wall. From the mark, make an 8” (203mm) circle. Cut out the circle with a jigsaw. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 24 Center the chimney support at the top of the back wall and secure with the provided screws. Attach the next part of the chimney support using the provided nut and bolts. Tighten with a wrench or socket. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 25 Install the cap on the top of the assembled chimney. Attached assemble chimney pieces to the “T” chimney stack section and secure with a bracket. Then place the end through the hole into the back of the stove. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 26 Install the bottom half of the exterior chimney shield with the provided screws. Ensure that it is level. Overlap the top half of the exterior chimney shield and secure with 4 of the provided screws. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 27 If a wood heater is installed, the vent can go on either side of the woodstove. Note, there is no inner vent cover for the back wall. tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...
- Page 28 This natural weathering will not harm the wood or impair the sauna’s performance. If you wish to retain the natural color of your Dundalk Leisurecraft Sauna, there are many cedar stains on the market and almost as many opinions as to which is best.
- Page 29 This warranty is a parts only warranty and any service or labor costs would not be considered as part of the 3-year warranty. Purchaser Name: ________________________ Date: _______________ Purchased From: ________________________ tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com...