A.O. Smith CAHP-80 User Manual page 5

Heat pump water heater
Hide thumbs Also See for CAHP-80:
Table of Contents

Advertisement

Water discharged from the heat pump (including high temperature heating water) shall not be used for
drinking.
The heat pump system shall be installed in a dry place. Never insert or disconnect from the power source
with a wet hand.
The heater shall be permanently connected to the electricity supply using a double pole linked switch that
has a contact separation of at least 3mm between poles incorporated in the circuit and out of reach from
the person using the shower. All wiring must conform to local requirements.
Do not use the damaged electric wire, aged, loose and incorrectly fixed power sources. This will prevent
the risk of electric shocks, short circuits, fires, etc. Ensure the power source is connected well.
If the supply cord is damaged, it must be replaced by AOS Bath in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge. They should be given supervision or instructions
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
A. O. SMITH Water Heating Company Ltd and AOS Bath Pte Ltd reserve all rights to interpret the
abovementioned provisions.
Caution
Failure to follow these instructions may lead to risk of fire and could cause property damage and or
personal injury or death. In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device such as a timer, or connected to
a circuit that is regularly switched on and off by the utility.
Warning
Power-on and operation will be permitted only after reliable grounding is provided for the power socket.
The heat pump system is strictly forbidden for use in circumstances where no safe grounding or well-
drained floor drain is provided. In the installation area, it should be ensured that the water leakage of the
heat pump system or joints may not cause damage to the articles in adjacent regions or lower portions of
the building.
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cahp-120

Table of Contents