Brush Replacement; Accessories - Craftsman 315.27984 Operator's Manual

BRUSH REPLACEMENT
Rgure 10.
• Unp[ugthe sander.
• Remove screws (3) fl'om top cover of sander.
• Remove top cover.
• Remove clamp screws (2.).
• Remove brush tube clamps (2).
• Disconnectred and black lead terminals fl'om brush
tubes.
• Remove brushassemblies (2).
• Check for wear. Replace both brush assemblieswhen
e(ther has tess than 1/4 in. length of carbon remaining.
Do not replace one side without replacing the other.
• Install new brush assemblies. Make sure curvature
of brush m_ches curvatureof motor and that brush
moves freely in brush tube.
• Reassembleby reversingthe steps listedabove.
• Tighten all screws securely. Do not overtighten.
BLACX
LEAD
Fig. _0
The following recommended accassodas are currentlyawitab_e at Sears retail stores:
• Aluminum Oxide Sheets With Paper Backing (1/4 Sheet)
X-Fine, Fine, Medium, Coarse
• Presaure-sensitTve Adhesive,Paper Backed Sheets(1/4 Sheet)
X-Fine, Fine, Medium, Coarse
• The FollowingStandard 4-1/2 in.X 11 in. Sanding Sheets Can Be Cut To Fit The Sander
X-Fine, Fine, Medium, Coarse
A WARNING: Current attanhments end accessoriesevailabla for use with this tsof are listedabove. Do not use any
attachments or accessoriesnot recommended by the manufacturerof this tool. The use of attachments or acces-
sor(es not recommsnde_ can resultIn ser(ouspersona(injury.
13