Bluetooth Function - Madison MAD-LPRETRO-MKII User Manual

7. Raise the arm using the cue lever and place the stylus vertically over the first track of the record. The
turntable will start turning automatically.
8. Use the cue lever to slowly place the stylus down onto the record's groove.
9. When the record comes to the end, the turntable will stop automatically if the auto-stop switch is on
the ON position. If it is in the OFF position, the turntable will continue to spin.
Note: If your record stops before the last track finishes, set the AUTO STOP switch to OFF. Your record
will now play to the end, but you will have to stop the turntable rotation manually.
Auto Stop
• When a record finishes playing, it can be controlled by the auto-stop ON/OFF switch.
• Lift up the tone arm and put it on the rest when finished.
• Replace the protective cap on the stylus and close the tone arm lock.
• Turn off the power at the mains.

Bluetooth Function

Set the input selector on BT/PHONO position.
Lift up the tone arm and put it on the rest. Then the BT function is ready for pairing.
Open your Bluetooth equipment and select MAD-LPRETRO in the list of found device.
In this mode, the turntable mode will stop automatically.
Radio Function
Set the input selector on AM or FM position.
Rotate the tuning dial on the desired radio station.
MAINTENANCE
REPLACING THE STYLUS
-Refer to the figures 1-8
1. Push the arm lock to release the tone arm.
2. Take off the cap of the cartridge to access the needle.
3. Separate slightly the cartridge from the socket.
©Copyright LOTRONIC 2018 MAD-LPRETRO-MKII 4