BELL+HOWELL TRIBURST 1078FEGU Quick Start Manual

4000
LUMENS
LED LIGHT
IMPORTANT SAFETY INSTRUCTIONS
• DUE TO TRIBURST HIGH INTENSITY LED BULBS, DO NOT STARE DIRECTLY INTO THE LED LIGHT.
• RISK OF ELECTRIC SHOCK - USE IN DRY LOCATION ONLY.
• The built-in outlet is only provided for linking one or more Triburst Shop Light units.
Do not plug anything else into it.
• Hooks are to engage the chain only. Do not hang the light by the electrical cord.
• Do not let the power cord hang low from the ceiling. Before using and installing this product,
please fix the power cord to the hanging chain using a cable tie to ensure safety.
• Use in open luminaire only.
• Please do not submerge the unit or cord with plug under the water.
• Do not use outdoors or in other wet, damp areas, or any hazardous environments
requiring failsafe performance.
• Plug is not waterproof, please keep it dry when in use.
• Do not place where it can fall into water, or near flammable materials.
• Do not use with wet hands or in any area with wet condition such as in bathrooms.
• Do not cover the unit with anything for the prevention of overheating.
• Do not expose the unit to direct sunlight or place it near wall heaters, space heaters,
radiators or enclosed space prone to temperature increase. Do not install on a
radiant-heating ceiling.
• Never operate this product if it is not working properly, if it has been dropped or
damaged, or if it has been dropped into water.
• Do not use with damaged cord or plug. If appliance is not working as it should, has
been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
• Do not use with damaged cord or plug.
• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord
around sharp edges or corners. Keep cord away from heated surfaces.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not stare directly into the LED light.
• Do not use with extension cord near water or where water may accumulate.
• Keep plugs and receptacles dry.
• When not in use and during cleaning, turn the unit off and unplug it.
• Do not use if properly grounded outlets are not available.
• Do not place any items on top of Shop Light while it's hanging.
• This device is not intended for use with emergency exits.
POLARIZED PLUG
This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to
reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Never use with an extension cord unless plug can be fully inserted. Do not alter the plug.
THE LEDs ARE NON REPLACEABLE.
INSTRUCTIONS
FOR INDOOR USE ONLY
CHAIN ASSEMBLY
1 2 3
Separate the chain in 2 parts: Attach each clip (total of 3) You can modify the length
3 on one side and 1 on the to the hooks located on the of the chain by removing
other, as shown above. top of the unit. Squeeze the the clip and repositioning it.
clip and attach.
INSTALLATION
IMPORTANT: Make sure the power cord reaches an outlet when determining
where to install the Triburst Shop Light.
1 2 3
Create an anchor hole in the Place each anchor over Push the ceiling hook
surface by using the drill or the hole and firmly tap into the anchor. Slowly
tapping a nail in with the it in until it is flush tighten the hook into
hammer. Do not make the with the surface. the plastic anchor.
hole wider than the anchor.
If nail was used, remove it
from surface.
Hang the Triburst Do not let the power cord hang low
5
4
Shop Light from the ceiling. Before using and
on the ceiling
installing this product, please fix the
hook. power cord to the hanging chain
using a cable tie to ensure safety.
USAGE
1 2
Insert a plug into the outlet. Press the Adjust the LED panels to the desired
toggle switch to ON position ( ) to position. Panels move up/down.
turn on the light. To turn the light off,
press the switch to opposite direction.
You may also link 1 or more Shop Lights (maximum of 10 lamps linked). Connect one
3
of the lights to the wall outlet, then use the power cord of the second light to plug into
the outlet located on the unit.
SPECIFICATIONS
• 120V, 60Hz, 800mA, 60W • 4000 Lumens
• Load of receptacle: Max.5A • 144 High Intensity LED Bulbs
• 90 degree adjustable panels
FCC STATEMENT
WARNING: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
BELL+HOWELL® TRIBURST™ SHOP LIGHT ITEM NO. 1078FEGU
DISTRIBUTED BY EMSON® NY, NY, 10001 ©2023 EMSON® ALL RIGHTS RESERVED. MADE IN CHINA.
1-800-423-4248