Remove the Product Attachments
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the left side of the dino's body,
use a screwdriver to loosen the screw, and then open the battery
cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
Carefully cut the two ties on the storage
door with a pair of scissors and discard.
Open the storage door. Take out the
paper inside the dino and discard.
4
4