Nikon F50 Instruction Manual page 28

5
Fully depress the shutter release button to take a
picture. The film automatically advances by one
frame.
- Shutter speed indication without ,,' , "should be
read as a reciprocal fraction, i.e.,
"15"
stands for
1/15 second,
"15"
H
for 15 seconds.
-In Single Servo AF mode,
if
a stationary subject
moves, remove your finger from the shutter
release button, then lightly press it again to
restart autofocus.
28
Using Built-In Flash
Use the built-in flash not only when the ready-
light blinks, but also when your subject is in
shadow or backlit.
See pages 51 to 55.
Auto Rewind
When the film reaches the end of the roll, auto
rewind begins. During rewinding,
e
and
~
blink
in the LCD panel. After rewind automatically
stops, frame counter shows E and
e
blinks for a
few seconds. You can then remove film
cartridge.
• When battery power is very weak, or when the
temperature is very low, fIlm may not rewind at
the end of roll; Err appears in the LCD panel. In
this case, replace battery with a fresh one, or
wait for the temperature to rise and then press
the rewind button.
To rewind film at mid-roll: Press the rewind
button at the bottom of the camera.