Table of Contents
Advertisement
Using the On-Screen Display (OSD) controls
To adjust the settings, the user controls can be viewed through the OSD.
Monitor control
Quik settings
Port setting
Advanced settings
To use the controls:
1. Press
to open the main OSD menu.
2. Use
or
function. If there is a sub-menu, you can move between options using
press
to select that function. Use
save.
3. Press
to move backwards through the sub-menus and exit from the OSD.
4. When VGA signal is connected, the Image position (H/V position), Clock and
Phase that Timing parameters of analog signal can store up to 16 sets of data.
5. Press and hold
adjustments to the OSD. Press and hold
allow adjustments to the OSD.
6. Enables DDC/CI by default. Use OSD Input Source Key, Press and hold
seconds to disable / enable DDC/CI function. The words "DDC/CI disable" shows
on the screen.
E22-30
Brightness
Volume
Mute
Contrast
Dynamic contrast
Over Drive
Color mode
Input Signal:
HDMI
Resolution:
1920 x 1080
to move among the icons. Select an icon and press
for 10 seconds to lock the OSD. This will prevent accidental
75
50
Off
75
Off
Off
Warm
Refresh Rate:
60Hz
or
to make adjustments then Press
for 10 seconds to unlock the OSD and
to access that
or
, then
to
for 10
2-4
Chapter 2.
Advertisement
Table of Contents
