Electrolux EIFLS60JIW1 Installation Instructions Manual page 11

Performing Installation Cycle
With your washer in fi nal location, perform an Installation Cycle to assist in proper installation.
If your washer has this console:
1. Empty washer's drum and close door.
2. After you plug in the washer the fi rst time: wake up the washer by pressing any button, rotate cycle knob to cycle
one up from lower right position (1), press the start button (3) and then the cancel button (4).
3. Wake up the washer again by pressing any button, then immediately and simultaneously press and hold buttons
2a and 2b for 5 seconds, or until the LCD display changes.
4. The LCD window will display
button (3). The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the
LCD window may display INSTAL PASS!, meaning your new washer is properly installed and ready for use. If it
prompts an action such as NO WATER, CHECK HOSES or CALL SERVICE 877 435 3287, review the
installation steps and make the necessary corrections before you attempt to use the washer.
5. Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately
run the washer through a washing cycle, press the cancel button to put the unit to sleep
and then rewake it immediately to continue the normal operating mode.
6. Please read the Use & Care Guide and enjoy your new premium washer!
If your washer has this console:
1. After you plug in the washer the fi rst time: wake up the washer by pressing any button and then follow the
prompts on the LCD User Interface, including language selection.
2. The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window
may display INSTAL PASS!, meaning your new washer is properly installed and ready for use. If it prompts an
action such as NO WATER, CHECK HOSES or
CALL SERVICE 877 435 3287, review the installation steps and make the necessary corrections before
you attempt to use the washer.
3. Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately
run the washer through a washing cycle, press the cancel button to put the unit to sleep
and then rewake it immediately to continue the normal operating mode.
4. Please read the Use & Care Guide and enjoy your new premium washer!
Installation Instructions
INSTAL CYCLE and show estimated time of cycle completion. Press the start
2a
2b
1
3 4
11