Table of Contents
Advertisement
● Leather band
• A leather band is susceptible to discoloration and deterioration from moisture, sweat and direct sunlight.
• Wipe off moisture and sweat as soon as possible by gently blotting them up with a dry cloth.
2
• Do not expose the watch to direct sunlight for a long time.
• Please take care when wearing a watch with light-colored band, as dirt is likely to show up.
• Refrain from wearing a leather band watch other than Aqua Free bands while bathing, swimming, and
when working with water even if the watch itself is water resistant enforced for daily use (10-BAR/20-BAR
water resistant).
● Polyurethane band
• A polyurethane band is susceptible to discoloration from light, and may be deteriorated by solvent or
atmospheric humidity.
• Especially a translucent, white, or pale colored band easily adsorbs other colors, resulting in color smears
or discoloration.
• Wash out dirt in water and clean it off with a dry cloth.
(Protect the watch body from water splashes by wrapping it up in plastic wrap etc.)
• When the band becomes less flexible, have the band replaced with a new one. If you continue to use
the band as it is, the band may develop cracks or become brittle over time.
25
EN
How to use tri-fold type clasp for leather band (Special clasps)
There are 3 types of special clasps as described below;
2
If the clasp of the watch you purchased is one of them, please refer to the indications.
A
A Type → P.28
B
B Type → P.29
27
EN
C
C Type → P.30
● Silicone band
• As for material characteristics, the band is easily dirtied, and may be stained and discolored.
Wipe off dirt with a wet cloth or cleaning tissue.
• Unlike bands of other materials, cracks may result in the band being cut. Take care not to damage the
band with an edged tool.
Notes on skin
Skin irritation caused by a band may result from various factors such as allergy to
irritation and
metals or leathers, or skin reactions against friction on dust or the band itself.
allergy
Adjust the band to allow a little clearance with your wrist to ensure proper
Notes on the
airflow.
length of the band
When wearing the watch, leave enough room to insert a finger between
the band and your wrist.
A
A Type
Lift up the clasp to release the buckle.
1
Buckle
Fixed loop
Flap
Movable loop
Open the flap.
2
EN
Remove the pin from the adjustment hole. Slide the
3
band left and right, and reinsert the pin into the
adjustment hole at an appropriate length.
Pin
Adjustment hole
Fasten the flap.
4
* Do not push the flap in too hard.
* When fastening the clasp, insert the tip of the band
into the movable loop and fixed loop, and then,
securely tighten the clasp.
EN
2
26
2
28
Advertisement
Table of Contents
