How To Use Tri-Fold Type Clasp For Leather Band (Special Clasps) - Seiko 8R46 Instructions Manual

How to use tri-fold type clasp for leather band (Special clasps)

There are 3 types of special clasps as described below;
If the clasp of the watch you purchased is one of them, please refer to the indications.
A
A Type → P.33
4
B
B Type → P.34
32
EN
B
B Type
4
While pressing the push buttons on both sides
1
of the flap, lift to open the clasp.
Push button
34
EN
C
C Type → P.35
Remove the pin from the adjustment hole.
2
Slide the band left and right, and insert the pin
into the adjustment hole at an appropriate
length. Push the buckle and fasten the clasp.
Buckle
Adjustment hole
Pin
A
A Type
Lift up the clasp to release the buckle.
1
Buckle
Flap
Fixed loop
Movable loop
Open the flap.
2
C
C Type
● How to wear or take off the watch
While pressing the push buttons on both sides
1
of the flap, pull the band out of the movable
loop and fixed loop. Then open the clasp.
Buckle
Push button
Fixed loop
Movable loop
Flap
Remove the pin from the adjustment hole. Slide the
3
band left and right, and reinsert the pin into the
adjustment hole at an appropriate length.
Pin
Adjustment hole
Fasten the flap.
4
* Do not push the flap in too hard.
* When fastening the clasp, insert the tip of the band
into the movable loop and fixed loop, and then,
securely tighten the clasp.
EN
Place the tip of the band into the movable loop
2
and fixed loop, and fasten the clasp by
pressing the frame of the buckle.
EN
4
33
4
35