Table of Contents
Advertisement
CONFIRMING THE PATTERN POSITION
CONFIRMING THE PATTERN
POSITION
The pattern is normally positioned in the center of the
embroidery frame. If the pattern needs to be repositioned
for better placement on the garment, you can check the
layout before starting embroidery.
Checking the Needle Drop Point with the
Embroidery Foot "W+" with LED Pointer
a
Touch
in the embroidery screen.
The LED pointer indicates the needle drop point.
Memo
• When the LED pointer turns on, the presser foot
height is automatically adjusted according to the
fabric thickness.
•
appears when the embroidery foot "W+" with
LED pointer is attached to the machine.
• If
is not displayed, you cannot use the LED
pointer.
• The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.
Note
• With spongy fabric, the position may not be
accurate due to the various depths of the fabric.
• With fabric that has a very uneven surface such as
quilting, the fabric thickness may not be correctly
measured. In this case, the pointer indication
should be used only as a reference.
Adjusting the LED Pointer
Adjust the LED pointer if it indicates a point different than
the actual needle drop point. Before adjusting the LED
pointer, mark the actual needle drop point on the fabric to
be embroidered, and attach the embroidery frame.
a
Touch
.
The settings screen appears.
b
Touch
.
The embroidery settings screen appears.
132
c
Display [Embroidery Foot with LED Pointer
Adjustment] in the embroidery setting screen.
Note
• As a default,
embroidery foot "W+" with LED pointer is attached
to the machine, the key becomes available and
settings can be specified.
d
Touch
.
The Embroidery Foot "W+" with LED Pointer
Adjustment screen appears.
1 LED pointer adjustment
Note
• The specified setting is saved in the machine's
memory. This is useful for positioning during
continuous embroidering.
• For normal use, return the setting to [00].
e
Use
or
to adjust the LED pointer so that it
indicates the actual needle drop point.
Memo
• In order to more accurately check the needle drop
point, turn the handwheel toward you
(counterclockwise) to lower the needle.
f
Touch
to return to the original screen.
Adjusting the Brightness of the LED Pointer
a
a
Follow the steps from
Pointer" on page 132 to display the embroidery foot
with LED pointer adjustment screen.
b
Use
or
to adjust the brightness of the LED
pointer.
c
Touch
to return to the original screen.
appears gray. After the
1
c
to
of "Adjusting the LED
Advertisement
Table of Contents
