Filling With Rinse Aid And Making The Setting - Whirlpool ADP 4209 Instructions For Use Manual

When the conditions of use of such products and the machine settings are appropriate,
•
they ensure savings in salt and/or rinse aid consumption.
Contact the detergent manufacturers if you are not obtaining good wash results (if your
•
dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of
warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage: If you want to obtain better results while using combined detergents,
add salt and rinse aid into your machine and adjust the water hardness setting and the rinse aid
setting to the lowest position.
Solubility of the tablet detergents produced by different companies can vary
depending on the temperature and time. Therefore, it is not recommended to use
such detergents in short programs. It is more suitable to use powder detergents in
such programs.
Warning: Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
•

Filling with rinse aid and making the setting.

Rinse aid is used to prevent the stay of white water drops, lime stains, white film strip-
aid compartment cap by turning
compartment with rinse aid until the rinse aid level indicator
You need to increase the degree of the adjuster if water stains form on your dishes after
a wash, whereas you need to decrease the degree if a blue stain is left when wiped by
hand. 3
shaped stains that may form on the dishes, as well as to increase
the drying performance. Contrary to the popular beliefs, it is used
not only for obtaining shinier dishes but also for obtaining sufficiently
dried dishes. For this reason, care
should be taken that there is
adequate amount of rinse aid in the
rinse aid compartment and only
polishing material produced for use
at dishwashers should be used.
To put rinse aid, remove the rinse
it.1 Fill the rinse aid
becomes dark;2 refit the cap and
close it by turning it in a way that
the nails will correspond to one another. By checking the rinse aid
level indicator on the detergent dispenser, you can understand
whether or not your machine needs rinse aid. A dark indicator
means that there is rinse aid in the compartment, while a light
indicator a shows that you need to fill the compartment with rinse
aid.
The rinse aid level adjuster can be set to a position between 1 and
6. Factory setting for rinse aid is the position 3.
48
b