Removing The Battery; Turning On And Off The Camera - Nikon COOLPIX P6000 User Manual

Removing the Battery

Before removing the battery, turn the camera off and
confirm that the power-on lamp and monitor are off.
To eject the battery, open the battery-chamber/
memory card slot cover and slide the battery latch in
the direction shown 1. The battery can then be
removed by hand 2.
• Note that the battery may become hot during use;
observe due caution when removing the battery.

Turning On and Off the Camera

Press the power switch to turn on the camera. The
power-on lamp (green) will flicker and the monitor will
turn on. To turn off the camera, press the power switch
again. When the camera turns off, both the power-on
lamp and the monitor will turn off.
• When the camera is off, holding down the c button
will turn the camera on in playback mode.
B
Notes on the Battery
• Be sure to read and follow the warnings and cautions of "For Your Safety" (Aiii), before using the
rechargeable battery.
• Be sure to read and follow the warnings for "The Battery" (A183) of the section "Caring for the
Camera", before using the battery.
• If the battery is not used for long periods of time, make sure to charge the battery once every half
a year, and keep the battery after it has been exhausted.
D
Auto Power Off in Shooting Mode (Standby Mode)
The monitor will dim to reduce the drain on the battery if no operations are performed for about five
seconds. The monitor will brighten when camera controls are used.
At default settings, the monitor will turn off altogether if no operations are performed for about a
minute during shooting and playback. The camera will turn off automatically if no operations are
performed for another three minutes (auto power off function).
To turn on the monitor when it's turned off, press the shutter-release button halfway or the c
button.
• The time taken until the monitor turns off completely can be changed in Auto off (A169) in the
setup menu (A159).
Inserting the Battery
17