Table of Contents
Advertisement
winIDEA Configuration
After connecting the hardware follow the steps below to configure the DAP over CAN Physical Layer
Converter in winIDEA:
1. Open Hardware menu / CPU Options.
2. Navigate to the SoC page.
3. Select DXCPL from the Debug channel Mode drop-down.
4. Confirm and establish the debug connection.
Refer to
isystem.com/connect
for more information on how to connect and configure the hardware.
Advertisement
Table of Contents
Need help?
Do you have a question about the IEA-DXCPL and is the answer not in the manual?