Advertisement
Advertisement
Table of Contents
Related Manuals for TASKING IEA-DXCPL
Summary of Contents for TASKING IEA-DXCPL
- Page 1 DAP over CAN User Manual V1.4, June 2023 isystem.com/start...
- Page 2 General safety instructions Please read the following safety precautions carefully before putting this device to use to avoid any personal injuries, damage to the instrument, or to the target system. Use this instrument only for its intended purpose as specified by this manual to prevent potential hazards. Use included power cord and power supply The enclosed power supply has been approved for use by iSYSTEM.
-
Page 3: Table Of Contents
Contents Introduction ............................4 Package content ..........................5 Operation ............................... 6 winIDEA Configuration ..........................8 Accessories ............................9... -
Page 4: Introduction
Introduction DAP over CAN Physical Layer Converter enables debugging via the regular CAN pins of the ECU connector without opening its housing. This connection is electrically robust due to the nature of the CAN bus. The DXCPL Converter translates Infineon AURIX™ SPD (Single Pin DAP) encoded DAP messages to the CAN bus physical layer. -
Page 5: Package Content
Package content The DAP over CAN Physical Layer Converter is delivered with the following components: DAP over CAN USB-C cable Physical Layer Converter Ordering code: IEA-DXCPL... -
Page 6: Operation
Operation Device overview Device description A – DAP connector Pinout valid on the DAP connector side: Signal Signal Direction Signal Signal Signal Direction Signal Description Description Reference Vref Transmitter voltage Ground Not Connected Ground Receiver Not Connected Not Connected Ground Not Connected DAP connector pinout Signal Direction is described from the BlueBox perspective. - Page 7 C – The LED indicator provides the status of the hardware as follows: Green – Powered on · Red – Power supply issue (e.g., burnt fuse) · D – Power supply connection for the Converter. Use provided USB-C cable to power the converter e.g.
-
Page 8: Winidea Configuration
winIDEA Configuration After connecting the hardware follow the steps below to configure the DAP over CAN Physical Layer Converter in winIDEA: 1. Open Hardware menu / CPU Options. 2. Navigate to the SoC page. 3. Select DXCPL from the Debug channel Mode drop-down. 4. -
Page 9: Accessories
Accessories DAP over CAN Physical Layer Converter is used together with the following iSYSTEM hardware: Description Ordering Code iC5700 BlueBox IC57000 Infineon DAP/DAPE II Active Probe IC57163-1 Infineon AGBT Active Probe IC57164 10-pin 1.27 mm DAP Adapter (Infineon AGBT IASAM22TRICOREPIN10 Active Probe) 1.0m FNet Cable (Active Probe) BB-FNET-100... - Page 10 Visit our website for: Support - isystem.com/support · Tutorials - isystem.com/getting-started · Knowledge Base - kb.isystem.com · www.isystem.com...
Need help?
Do you have a question about the IEA-DXCPL and is the answer not in the manual?
Questions and answers