Advertisement
Functional Test Cycle
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S3 to start the test cycle. The cycle will not start if
door is opened.
L3 blinks for the duration of the test cycle.
Display shows the remaining time of test cycle.
The test cycle runs as a normal wash cycle. It can be
cancelled or run to its end.
Enable/disable Extra Rinse
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S1+S2 to enter this function.
L1 blinks indicating it is in Extra Rinse setting mode.
Display show the current setting of Extra Rinse. "0E" for
disabled, "1E" for enabled.
2. Press button S1 to change the setting.
3. Switching off the appliance will exit Service mode.
Technical Support – RA
EDW1600
Enable/disable Pulse Wash
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S2+S3 to enter this function.
L2 blinks indicating it is in Pulse Wash setting mode.
Display show the current setting of Pulse Wash. "0P" for
disabled, "1P" for enabled
2. Press button S2 to change the setting
3. Switching off the appliance will exit Service mode.
3
Chapter
Advertisement
