Advertisement
User Interface – Modes and Function description
Reset
"Reset" is a special kind of User Operation to stop or deselect a
running program. In Dorothea range, when this function is
performed, the appliance will be in Startup mode with ECO program
and its default option selected.
Reset can be performed in any state except the Startup mode.
Reset is done by pressing the reset key combination for at least 2
seconds or press the specific button dedicated to this function by
the custom software.
The Reset key combination or specific Reset key is clearly indicated
on the control panel as 'Reset' or 'Cancel'.
User Mode
The full function User Mode includes:
•
Water Hardness Setting
•
Rinse Aid Level Setting
•
End of Cycle Buzzer Setting
•
Display on Floor Display Colour Setting
•
ADO Setting
Technical Support – RA
User interface – Introduction
According to hardware configuration of the dishwasher and
marketing requirement, User Mode in individual models can be a
subset of above functions.
The User Mode functions are not described in this Service Manual
since they are available on the User Manual.
Service Mode
The full function Service Mode includes:
•
Fault Memory Reading
•
Actuator Test
•
LEDTest
•
Functional Test cycle
•
Enable/disable Extra Rinse
•
Enable/disable Pulse Wash
•
LCD brightness setting
•
LCD contrast setting
According to hardware configuration of the dishwasher and
marketing requirement, Service Mode in individual models can be a
subset of above functions.
All the Service Mode functions are described on this user Service
Manual.
2
Chapter
Advertisement
