Operation Instructions; Maintenance - Rinnai RRSH2 User Instructions

Ignition of Burner
Ensure the flame control knob is at the off position "". Press and turn the knob in anti-clockwise
direction to ignition position. Keep pressing the knob for 5 seconds. (A clack sound is emitted when
the knob reaches the ignition position). After releasing the knob, make sure the flame persists.
Attention: If the appliance has not been used for a long time, the first ignition may not succeed
due to trapped air in gas pipe. Turn the flame control knob to the off position "". Repeat the
above ignition procedures until success of ignition.
Flame Control
After ignition, turn the rotary knob to adjust flame power according to cooking needs. Please adjust
slowly.
When adjust flame power from maximum close to medium, if flame of outer ring burner is found
unstable (weak or extinguished), please adjust the flame power to maximum until flame of outer ring
burner is stable, or reduce flame power and use flame of simmer burner.
Medium
Rotary knob
position
Flame Extinguishing
Turn the flame control knob to the off position "".
Attention: Pop sound may be generated during the flame extinguishing due to instant
combustion of gas remained in burner. This is a normal phenomenon.
Attention: Allow the appliance to cool down completely before performing any maintenance and
cleaning. Wear gloves to protect the hands while cleaning.
To maintain the appliance properly, follow the following instructions to clean it regularly:
 Do not use steam cleaners for cleaning;
 The metal and enameled parts must be cleaned with suitable non-abrasive and non-corrosive
detergents. Avoid using chlorine-based detergents (e.g. bleach) for cleaning;
 Avoid leaving acidic or alkaline substances on the appliance (e.g. vinegar, brine, lemon juice, etc.);
 Clean and tidy up the burners after spillage of liquid once it cools down;
 The burner caps must be washed regularly with warm water and detergent. Remove any grime and
keep the flame holes of burner away from blockage;
 Dry the burner caps completely after washing and check all flame holes of burner are not clogged;

Replace burner caps onto burner base. Ensure that they are not tilted or reversed;

Regularly check the flame failure device . In case of sticking with stains, clean it with soft brush.
Operating Instructions
Ignition /
Medium
Maximum

Maintenance

5
Minimum Off position