ABB ControlMaster CM50 Manual page 14

14 C O N T R O L M A S T E R C M 3 0 & C M 5 0 | P R O C E S S C O N T R O L L E R S , 1/4 & 1/2 D I N | C I/C M 3 0/ 5 0 - E N R E V. C
...3 Installation
...Mounting
Referring to Figure 4:
1 Position one panel clamp
against the panel.
2 Locate the panel clamp anchor
3 Tighten the panel clamp anchor screw
A
panel clamp is lightly touching the panel
4 Repeat steps 1 to 3 to fit the remaining panel clamp
E and panel clamp anchor
5 Torque tighten both panel clamp anchor screws to
0.1 N⋅m (0.9 lbf⋅in).
NOTICE
Do not over-tighten the screws.
A at the top of the case
B in slot C .
D until
F
Figure 4 Panel clamp assembly