Table of Contents
Advertisement
ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN1/2)
Connect the fan cables to the fan connectors on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the connector.
Intel
®
Install Intel
designed for 6th Generation Intel
processors.
M.2 socket 3
This socket allows you to install an M.2 (NGFF) SSD module.
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
1-2
•
For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 350 W.
•
If you are uncertain about the minimum power supply requirement for your
system, refer to the Recommended Power Supply Wattage Calculator
at http://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-us for details.
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! Do not place jumper caps on the fan connectors! The CPU_FAN
connector supports a CPU fan of maximum 1A (12 W) fan power.
LGA1151 CPU socket
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
For more details, refer to Central Processing Unit (CPU).
•
This socket supports M Key and 2242/2260/2280
storage devices.
•
When using Intel
technologies with PCIe M.2 device, ensure to set
up the Windows
RAID mode.
For more details, refer to System memory.
Core™ i7 / i5 / i3, Pentium
®
Desktop Responsiveness
®
UEFI operating system under
®
, and Celeron
®
M.2(SOCKET3)
Chapter 1: Product introduction
®
Advertisement
Table of Contents
