Advertisement
Installing the UB-P500 in the Printer
1.
Remove the two screws that securing the interface board; then pull the
board and remove it. You will use the screws when installing the UB-
P500.
CAUTION:
Put the removed interface board into an anti-static bag for storage to
prevent damage from static electricity.
2.
Hold the UB-P500 as shown in the illustration below. Push the UB-P500 in
gently until you feel the connector fits into place.
Connector of
the UB-P500
Connector of the
EU-T482 series
3.
Secure the UB-P500 with the two screws.
4.
Change the printer settings to match the printer to the new interface. See
the printer documentation for the settings.
Note:
Be sure to make the printer settings, or the printer may not work correctly.
Standards and Approvals
The following standards are applied only to the interface boards that are so labeled. (EMC is tested using the
EPSON power supplies and EU-T482 series.)
Europe:
CE marking
North America: FCC/ICES-003 Class A
Oceania:
AS/NZS CISPR22 Class A
This is a Class A product. In a domestic environment this product may cause radio interference, in which
case the user may be required to take adequate measures.
The printers in which this board is installed becomes class A devices.
The connection of a non-shielded printer interface cable to this board will invalidate the EMC standards of
this device.
You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could
void your authority to operate the equipment.
WARNING
2
Advertisement
