Electrolux ESL 43020 User Manual page 14

14 electrolux
Malfunction
The anti-flood • The light of the pro-
device operates.
• The end-of-programme
The programme
does not start.
After the check, switch on the appliance. The
programme continues from the point of in-
terruption.
If the malfunction shows again, contact the
service centre.
For other fault codes, not showed in the
chart, contact the service centre.
The necessary data for the service centre is
on the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
Fault code
gramme in progress
flashes.
indicator light flashes 3
times.
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch all
surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Possible cause
The water drain hose is
damaged.
The appliance door is
open.
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Make sure that the washing pro-
gramme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt container
cap is closed correctly.
Possible solution
Make sure that the water
drain hose has no dam-
ages.
Close the water tap and
contact the service cen-
tre.
Close the door correctly.
Put in the mains plug.
Replace the fuse.
....................
....................
....................
Possible solution