Electrolux EWX 14450 W User Manual page 32

32 electrolux
A
When installing the appliance into the kitch-
en furniture ensure, if possible, the hoses
are placed in either of the two recesses on
the back of the appliance.
This will help to prevent the hoses from be-
coming kinked or trapped.
Preparation and assembly of the door
The machine is originally prearranged for
the assembly of a door opening from right
to left.
In this case it is sufficient to screw in the
hinges (1) and the counter-magnet (6) pro-
vided with the appliance, at the right level
(Fig. B).
B
6
1
2
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
5
7
3
The height (C-Fig. C) depends on the height
of the adjacent furniture's base.
C
b) Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth 12.5-14 mm
depending on the depth of door furniture)
on the inner side of the door. The distance
between the holes hobs fixing centres must
be 416 mm.
The distance (B) from upper edge of the
door to the centre of the hole depends on
the adjacent furniture's dimensions.
The required dimensions are given in the
picture C.
The hinges will be fixed to the door by
means of screws for wood (2-Fig. B) sup-
plied with the appliance.
c) Mounting the door
4
Fix the hinges (1) to the machine by means
of the M 5x15 screws (3-Fig. B). The hinges
can be adjusted to compensate for possi-
ble uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door
and tighten the screw again.
d) Counter-magnet (6)
The appliance is prearranged for a magnet-
ic closure of the door.
To enable a correct operation of this device,
it is necessary to screw the counter-magnet
(6) (steel disk + rubber ring) into the inner
side of the door. Its position must corre-
spond to the magnet (4) on the appliance
(see picture D).