Table of Contents
Advertisement
NOTE:
• After pushing the door handle button, you must
wait two seconds before you can lock or unlock
the doors, using either passive entry door
handle. This is done to allow you to check if the
vehicle is locked by pulling the door handle
without the vehicle reacting and unlocking.
• If passive entry is disabled using Uconnect
System, the key protection described in "Pre-
venting Inadvertent Locking of Passive Entry
Key Fob in Vehicle" remains active/functional.
• The Passive Entry system will not operate if the
key fob battery is dead.
Lock Or Unlock The Liftgate
With a valid Keyless Enter-N-Go key fob within
5 feet (1.5 meters) of the liftgate, push the elec-
tronic liftgate lock/unlock pad located to the left of
the liftgate handle to unlock the liftgate. Push the
button a second time to lock the liftgate.
Electronic Liftgate Lock/Unlock Pad
For further information, and applicable warnings
and cautions, please refer to the Owner's Manual at
https://www.mopar.com/en-us/care/ownersmanual.html
(U.S. Residents) or www.owners.mopar.ca (Canadian
Residents).
R E M O T E S T A R T
Remote Start — If Equipped
Push the remote start button
twice within five seconds. Pushing the remote
start button a third time shuts the engine off.
With Remote Start, the engine will only run for
15 minutes (timeout) unless the keyless ignition is
placed in the ON/RUN position.
Before the end of 15-minute cycle, push and
release the unlock button on the key fob to unlock
the doors and disarm the vehicle security alarm
(if equipped). Then, prior to the end of the 15-
minute cycle, push and release the ignition
START/STOP button.
The vehicle must be started with the key fob after
two consecutive timeouts.
For further information, and applicable warnings
and cautions, please refer to the Owner's Manual at
https://www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Canadian
Residents).
on the key fob
Advertisement
Table of Contents
