Table of Contents
Advertisement
What to do if ...
Before contacting your local Service Force Centre, check the following
points.
No power to the appliance.
Appliance cools too much.
The temperature in the refrigerator/
freezer is too high.
Temperature display shows a square or a
letter.
Warning tone sounds, red warning display
is flashing.
Warning tone sounds, red warning display
and freezer temperature display are
flashing.
Interior illumination does not function.
Important: The interior lighting switches
off automatically after 7 minutes.
Excessive build up of frost.
818 36 54-00/6
Symptom
Solution
Check there is power at the socket
Check there is not a power cut by
checking the household lights.
Check the fuse has not blown.
Temperature is set too cold.
Temporarily select a higher temperature
setting.
Check the ambient temperature is within
the appliances operating limits
Check the temperature setting is correct
relative to ambient conditions.
There is a function fault.
Please contact your local Service Force
Centre. Do not open the door of the
appliance again.
"Open door" warning.
Please check in "Control and Information
System" section.
Temperature warning for freezer.
Please check in "Control and Information
System" section.
Please refer to "Replace Light Bulb "
section.
If the door seal is not airtight (probably
after reversing the door) apply warm air
to the non sealing area using a hair dryer
set to a gentle heat. (do not use a fan
heater for this purpose). This will make
the rubber more supple and allow it to
revert to its original shape.
43
Advertisement
Table of Contents
