Displaying Information; List Of Viewable Messages; End Of Shift - Maidaid Halcyon C612 User's Installation Manual

UK
N.B. Do not switch off the machine if a regeneration cycle is underway

By holding the START button (4) pressed for a few seconds you can display in sequence the Boiler
temperature, the Tub temperature and the number of cycles performed by the machine.
This information can be displayed both before and during the wash cycle and will only be visible
temporarily.

By holding the PROGRAMME SELECTION button (3) pressed for a few seconds you can display in
sequence the Boiler temperature, the Tub temperature and the number of cycles performed by the
machine.

The function can be activated by holding the PROGRAMME SELECTION button (3) pressed for a
few seconds.

At the end of the day always drain the machine as described in the section Machine draining.

Disconnect the power supply by means of the main switch and close the external water cock.

Perform routine maintenance and clean the machine as described in the section Maintenance.

If possible, leave the door ajar to prevent bad odours building up inside the machine.
Page 10 of 14
INSTRUCTION MANUAL FOR DISHWASHERS
Door open
Rinse temperature
Wash temperature
Regeneration cycle or request
No salt in the softener

4.12 Displaying information

4.13 List of viewable messages

Number of cycles
carried out
End of cycle
Automatic start
enabled
Continuous wash
Service

4.14 End of shift