Table of Contents
Advertisement
Figure 89
1. Deck-lift pedal
2. Height-of-cut pin
6.
Insert the height-adjustment pin into the 7.6 cm
(3 inch) cutting-height position.
7.
Release the transport lock and allow the deck to
lower to the cutting height.
8.
Raise the discharge chute.
9.
On both sides of the deck, measure from the
level surface to the front tip of the blade (Position
A); refer to
Figure
Note:
The measurement should read 7.6 mm
(3 inches).
3. Transport lock
90.
1. 7.6 cm (3 inches) at
position A is correct
2. 8.3 cm (3–1/4 inches) at
g027343
position B is correct
10.
If needed, loosen the flanged locknut on the side
of the yoke and the jam nut on top. Fine-tune
the adjuster screw by turning it to get 7.6 mm (3
inch) height
Note:
To increase the height, turn the adjuster
screw clockwise; to decrease the height, turn it
counterclockwise.
1. Flanged locknut
2. Adjuster screw
11.
If the front deck links do not have enough
adjustment to achieve the accurate cut height,
you can use the single point adjustment can be
utilized to gain more adjustment.
12.
To adjust the single point system, loosen the 2
bolts at the bottom of the height-of-cut plate.
Refer to
60
Figure 90
3. Measure here, from the
blade tip, to the hard
surface
4. Measure at position A and
B on both sides
(Figure
91).
Figure 91
3. Jam nut
4. Yoke
Figure
92.
g009196
g010251
Advertisement
Table of Contents
