Power distribution board and bracket
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the power supply assembly. See "Power supply assembly" on page 67.
2. Remove the left side cover. See "Left side cover" on page 72.
3. Remove the right side cover. See "Right side cover" on page 97.
4. Remove the PSU bay storage enclosure. See "Hard disk drive in the PSU bay storage enclosure" on
page 95.
Removal steps
Loosen the three screws to remove the power distribution board and bracket.
Note: The three screws cannot be removed from the power distribution board bracket.
.
Chapter 7
Hardware removal and installation
101