Advertisement
Advertisement
Table of Contents
Related Manuals for Tech 21 SansAmp RPM
Summary of Contents for Tech 21 SansAmp RPM
-
Page 2: Important Safety Instructions
230V and 240V units: use F 0.5A L QUICK START INSTRUCTIONS Get your SansAmp RPM up and running before reading the entire manual. But by not reading the manual, you’ll miss out on getting the most out of your new investment! 1. -
Page 3: Front Panel
RPM as a permanent part of a rack or patch-bay system, with its usual input source plugged into the rear panel jack. Then, if you want to plug straight into the SansAmp RPM, bypassing other gear in the system, you can use the SansAmp RPM’s front Input. -
Page 4: Effects Loop
SansAmp RPM signal goes through your effects processor, and the other 50% passes directly to the SansAmp 1/4" and XLR Outputs. To preserve the signal integrity of the SansAmp RPM, use the Effects Loop with the Mix 50/50 switch engaged. When the SansAmp RPM is in this mode, the effects proces- sor’s mix control should be set at 100% wet. - Page 5 Note: With on-going product development and improvements, specifications and/or the cosmetic appearance of this unit may change without prior notice. Replacement parts are available, i.e., knobs, rack handles, faceplate, etc. For more information, please contact your authorized dealer or Tech 21, Inc. Model Number: Input Impedance-Input 1: 4.7MOhm...
Need help?
Do you have a question about the SansAmp RPM and is the answer not in the manual?
Questions and answers