Assistant AH-1023 - Desktop Led Clock Manual

Assistant AH-1023 - Desktop Led Clock Manual

Advertisement

Assistant AH-1023 - Desktop Led Clock Manual

APPEARANCE

Device Overview

  1. ALARM indicator
  2. PM indicator
  3. [SNOOZE] button
  4. [HOUR] button
  5. [MINUTE] button
  6. [TIME] button
  7. [ALARM] button
  8. [ALARM ON/OFF] switch
  9. [DIMMER HI/LOW] switch

CLOCK OPERATING

Blinking Display/PM Indicator/Alarm Indicator
When the clock is plugged in, the display will blink on and off meaning that incorrect time is being displayed. You should always check the time, when this is indicated. The clock will automatically indicate AM/PM, but you must be sure to set the indicator for the time of alarm correctly. When the PM indicator is on, it is "PM", when it is off, it indicates "AM". When the Alarm indicator is on, the alarm will sound at the time set.

TIME SETTING

Press and hold the [TIME] button and the [HOUR] button until the correct hour is displayed (and the AM/PM is correct), then release the [HOUR] button and press the [MINUTE] button until the correct minutes are displayed.

ALARM SETTING

Press and hold the [ALARM] button and the [HOUR] or the [MINUTE] button as above. Be sure the set the AM/PM properly too.

TO OPERATE THE ALARM

Slide the [ALARM ON/OFF] switch to the "ON" position. The alarm will sound at the time set. To shut off the alarm, slide the [ALARM ON/OFF] switch to the "OFF" position.

SNOOZE

Press the [SNOOZE] button and get extra 8~9 minutes of sleep.

HI/LOW DIMMER SWITCH

If more intense display is preferred, slide the [DIMMER HI/LOW] switch to the "HI" position. If less intense display is desired, slide the [DIMMER HI/LOW] switch to the "LOW" position.

BATTERY BACKUP

Insert one 9V battery into the battery compartment on the back side of the clock. The battery will hold the alarm and time setting until the power is restored. If there is no battery and the power is interrupted, the display will fl ash and the alarm and the time will need to be reset.

MAINTENANCE

A soft cloth or a paper towel may be used to clean the clock. Do not use any corrosive cleansers or chemical solutions on the clock. Keep the clock clean and dry to avoid any problems.

WWW.TIWELL.COM
WWW.ASSISTANT.UA

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Assistant AH-1023 - Desktop Led Clock Manual

Advertisement

Need help?

Need help?

Do you have a question about the AH-1023 and is the answer not in the manual?

Questions and answers

Table of Contents