Advertisement
Under some conditions, the unit may not deliver a nail when the air pressure dial is turned to the MAXIMUM pressure setting. The user may need to decrease the pressure setting for desired operation.
NOTICE:
Remove battery pack before performing any of the steps described below.
Driving too deeply into the material, excess debris, or jammed nails may lead to a driver blade being stuck at its bottom position.
The driver blade can usually be returned to its operating position by depressing the work contact element against a scrap piece of wood and squeezing the trigger.
If this does not automatically return the drive blade into the tool, remove the battery and refer to the figure 2 and instructions in the operators manual on removing a jammed nail.
For Ryobi Customer Service call 1-800-525-2579.
ONE WORLD TECHNOLOGIES, INC.
1428 Pearman Dairy Road, Anderson, SC 29625
USA
1-800-525-2579 • www.ryobitools.com
A subsidiary of Techtronic Industries Co., Ltd.
OTC: TTNDY
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the P320 that isn't answered in the manual? Leave your question here.