UPPAbaby BabyGanoosh 0120 - Footmuff Installation Manual

INSTALLATION

NOTE: Remove canopy from stroller prior to BabyGanoosh installation. (Refer to your stroller's instruction manual.)

1. Unlock stroller harness straps and place BabyGanoosh in stroller seat.
   
2. Place top flap over stroller seat to secure BabyGanoosh in place.
   
3. After unzipping BabyGanoosh, pull both shoulder safety straps through corresponding slots on the BabyGanoosh.
   NOTE: You must unhook shoulder straps from waist safety straps to do this. (Refer to stroller instruction manual for steps.)
   
4. Pull bottom buckle and waist safety straps through corresponding slots on the BabyGanoosh. Reattach shoulder straps to waist safety straps. Replace stroller canopy.
   

CLEANING	Machine wash in cold water on gentle cycle with mild detergent.	Tumble dry low. Cool iron if needed.	DO NOT bleach or dry clean.

FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. READ ALL INSTRUCTIONS BEFORE USE:
NEVER leave child unattended in this product.

• Do not use as sleepwear.
• This product is not flame retardant or resistant and is not intended for use in children's sleepwear as defined in FF3-71 and FF5-74 of the rules and regulations of the Consumer Product Safety Commission.
• Do not allow any part of this product (or any fabric) to cover a child's nose or mouth.
• Do not allow child to become overheated.
• Always re-adjust and secure stroller harness straps and buckles when using the BabyGanoosh.