Asus MB16AHV User Manual page 25

Problem
After connecting with the USB Type-C
source device, the power LED lights
continuously blinking or showing ASUS
logo repeatly
*1: White color background will consume higher power, so it's better to use white color
background to test the power limit from source USB Type-C device.
*2: If the monitor does not re-start when adjusting to value 100, that means source USB Type-C
device has sufficient power supply.
ASUS USB Type-C Monitor MB16AHV
Possible Solution
• Insufficient power supply from source
USB Type-C devices. Please follow below
steps:
1. Press the Blue Light Filter button , and
then connect the USB Type-C cable.
This operation will enable built-in safe
mode. After displaying ASUS logo, please
release the Blue Light Filter button. After
ASUS Logo disappearing, there is "safe
mode" message OSD showing up. Once
"safe mode" message OSD disappears,
please set background color to white
image or nearly white image (*1).
2. Press MENU button, main menu OSD
is showing. The upper left corner of the
OSD will display small red-colored font
"S", indicating it is now in safe mode.
Enter brightness setup, press the up key
to tune up brightness. During the process,
please note down brightness value "Y" up
until MB16AC re-start.(*2). For example, if
brightness value shows "70" and MB16AC
restarts when adjusting to "71", "70" is the
"Y" value to note down and is the highest
brightness value for the connecting USB-C
source device.
3. Press MENU button, main menu OSD
is showing. The upper left corner still
indicate "S" as safe mode. Adjust the OSD
brightness value to "Y"
4. Close the OSD and press Low Blue Low
Filter hot key for 5 seconds to turn off safe
mode.
5. Complete.
3-11