Download Print this page

Braun cruZer 6 clean shave Manual page 6

Hide thumbs Also See for cruZer 6 clean shave:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
4
Charging light (green)
5
Low-charge light (red)
6
Replacement light for shaving parts
7
Shaver power socket
8
Special cord set
9
Protection cap
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C.
The battery may not charge properly or at all under extreme low or high
temperatures.
Recommended ambient temperature for shaving is 15 °C to 35 °C.
Do not expose the shaver to temperatures higher than 50 °C for extended
periods of time.
• Using the special cord set (8), connect the shaver to an electrical outlet with
the motor switched off.
• When charging for the first time or when the shaver is not used for a few
months, leave the shaver to charge continuously for 4 hours.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 45 minutes of cordless shaving time depending
on your beard growth. However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• 5-minute quick charge is sufficient for a shave.
Charging light (4)
The green charging light shows the status of the batteries. The green
charging light blinks when the shaver is being charged or switched on.
When the battery is fully charged, the green charging light shines
permanently, provided the shaver is connected to an electrical outlet.
Low-charge light (5)
The red low-charge light flashes when the battery is running low.
You should be able to finish your shave.
Shaving
Press the on/off switch (3) to operate the shaver (picture).
The flexible shaving foils automatically adjust to every contour of your face
(picture).
7

Advertisement

loading

This manual is also suitable for:

5414