Lens - THOMSON grass valley LDK 6000 MKII Series User Manual

Lens

4
To attach a lens to the camera head proceed as follows:
a. Ensure that the lens locking ring (1) is in the unlocked
position - turned counterclockwise.
b. Remove the dust protection cap (2).
c. Slot the lens into the lens mount (3).
d. Turn the lens locking ring (1) clockwise to lock the lens in
place.
e. Connect the lens cable to the lens connector (4) at the
right side of the camera.
f. Place the lens cable into the bottom clip at the front of the
camera and clip (5) located at the side. (Pull and twist clip
(5) to open it.)
CAUTION
Do not attach a lens weighing more than 5 kg to the
camera without a support.
When a new lens is fitted to the camera it may be necessary
to carry out some adjustments to optimize its use, for example,
back focus or shading. For more information about these
adjustments refer to Section 5 and to the lens manufacturer's
documentation.
Note: Always mount the dust protection cap when the lens
is not connected to the camera.
Assembling the Units
3
5
Operator's Manual - LDK 6000 mkII
1
2
bts1009
2-3