Storage; Troubleshooting - Bosch MUM54R00/06 Instruction Manual

en

Storage

Cleaning the bowl and tools
The bowl and tools are dishwasher­proof. Do
not wedge plastic parts in the dishwasher, as
they could be permanently deformed during
the washing process!
Cleaning the continuous-feed
shredder
W Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the
cutting discs. Clean them with a brush.
All parts of the continuous­feed shredder are
dishwasher­proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on a
cloth and rub the film off the continuous­feed
shredder (not the cutting discs). Then rinse
the continuous­feed shredder.
Cleaning the blender
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands.
The blender jug, lid and funnel are
dishwasher­proof.
Tip: After processing liquids, it is often suffi­
cient to clean the blender without removing
it from the appliance. Pour 700 ml of water
and a drop of washing­up liquid into the
attached blender. Switch on the blender for
aproximately 1 minute (setting 7 (4)). Pour
out the water and rinse out the blender with
clear water.
Important information
If required, clean accessories bag. Follow
care instructions in the bag.
Storage
W Risk of injury!
When the appliance is not in use, pull out the
mains plug.
Fig. J:
■ Store tools and cutting discs in the acces­
sories bag.
■ Keep accessories bag in the bowl.
30

Troubleshooting

W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
Important information for
MUM54../MUM55../MUM56..
The Operating indicator flashes if the appli­
ance has been operated incorrectly or the
electronic fuse has tripped or the appliance
is defective.
The swivel arm must be engaged in every
operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on as
far as possible.
■ Attach drive cover to unused drives.
■ The safety lock is active. Switch appliance
to P and then back to the required setting.
Fault
Appliance switches off during use. The over­
load protection feature has been activated.
Too much food was processed at one time.
Remedial action
■ Switch off the appliance.
■ Reduce processing quantity.
Fault
While the drive was running, the release
button was inadvertently pressed. The swivel
arm moves up. The drive switches off, but
does not stop in the tool change position.
Remedial action
■ Set the rotary switch to P.
■ Move swivel arm to position 1.
■ Switch on appliance (setting 1).
Printed on 100% recycled paper