Intended use End of programme ....23 Intended use Switching off automatically after the end of the programme ..23 In t e n d e d u s e Switching off the appliance.
Safety instructions Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power ■ that the back cable. of the dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface).
Safety instructions If the dishwasher is installed Do not install the appliance ■ ■ below or above other near heat sources (radiators, domestic appliances, follow heat storage tanks, cookers the information for installation or other appliances which in combination with generate heat) and do not a dishwasher install under a hob.
Safety instructions Childproof lock (door lock) Damage D o o r l o c k The description of the The appliance may be ■ childproof lock is at the back in repaired and opened up by a the envelope. technician only. To do this, disconnect the appliance * depending on model from the power supply.
Page 8
Safety instructions Warning Warning Risk of injury! Risk of explosion! To prevent injuries, e.g. Do not add any solvents ■ ■ caused by stumbling, open to the washing chamber. the dishwasher only briefly Danger of explosion! in order to load and unload If you use highly caustic ■...
Protection of the environment Keep children away from ■ Protection of the open dishwasher. There may environment be small parts in the dishwasher which children P r o t e c t io n o f th e e n v i ro n m e n t could swallow and the water Both the packaging of new appliances and the old appliances themselves...
Getting to know your appliance Overview of menu Getting to know your appliance The settings can be found in the individual chapters. G e t tin g to k n o w y o u r a p p l ia n c e •...
Water softening system/Special salt 3. Close the door. Using special salt 4. Switch on ON/OFF switch (. 5. Hold down programme button # Always refill with special salt and press START button P until immediately before switching on the •:‹..is indicated on the digital appliance.
Rinse aid Using detergents with salt Rinse aid replacement substances D e t e r g e n t s w i t h s a l t r e p l a c e m e n t s u b s t a n c e s R in s e a i d As soon as the rinse-aid refill According to the manufacturers,...
Rinse aid Setting amount of rinse aid Switching off rinse aid refill indicator The amount of rinse aid can be set from §:‹‹ to §:‹‡. Please set rinse aid on §:‹… to obtain very good drying results If the rinse-aid refill indicator h is impaired (e.g.
Utensils Loading the dishwasher Utensils U te n s ils Using the dishwasher normally allows you to save energy and water compared Not suitable to washing-up by hand. 1. Remove large food remnants. Cutlery and utensils made of wood. ■ Prerinsing under running water is not Delicate decorative glasses, craft ■...
Utensils Cups and glasses Pans Top basket 1" Bottom basket 1b Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 12. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully.
Utensils E tagere * Small accessories holder * E t a g e r e S m a l l a c c e s s o r i e s h o l d e r The etagere and the space underneath * depending on model can be used for small cups and glasses Light-weight plastic accessories, e.g.
Utensils A djusting the height of the 3. To raise the basket, hold the basket A d j u s t i n g t h e h e i g h t o f t h e b a s k e t on the sides of the upper edge and basket * lift it up.
Detergent Adding detergent Detergent 1. If the detergent dispenser 9" is still D e t e r g e n t closed, press the lock 9* to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing-up liquid.
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing ■ slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets ■...
Overview of programmes Overview of programmes O v e r v i e w o f p r o g r a m m e s The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling.
Operating the appliance Switching on the appliance Operating the appliance 1. Turn on the tap fully. 2. Switch on ON/OFF switch (. O p e r a t in g th e a p p l ia n c e The Eco 50°...
Operating the appliance T imer programming * 1. Close the door. T i m e r p r o g r a m m i n g 2. Switch on ON/OFF switch (. 3. Hold down programme button # * depending on model and press START button P until •:‹...
Operating the appliance Interrupting the programme Intensive drying 1. Switch off ON/OFF switch (. The final rinse uses a higher temperature which improves the drying The LEDs go out. The programme is result. The running time may increase saved. slightly. (Caution if utensils are delicate!) If the door was opened on an appliance which has a warm water 1.
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance C le a n i n g a n d m a i n t e n a n c e and fascia with a damp cloth;...
Cleaning and maintenance The filter system consists of a coarse Spray arms filter, a flat fine filter and a microfilter. 1. After each washing cycle check the Limescale filters for residue. and contaminants in the rinsing water may block nozzles 2.
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t, w h a t to d o ? the appliance from the power supply. Experience has shown that you can 2.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display X lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min.
Page 29
Fault, what to do? Fault Cause Remedial action Error code “:ƒ† is lit. Waste water pump blocked or Clean pump and lock cover correctly. (See cover on the waste water pump is “Waste water pump”) not locked in position. Error code “:ƒˆ is lit. Mains voltage too low.
Page 30
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 31
Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 32
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Page 33
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
Page 34
Fault, what to do? Fault Cause Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
Page 35
Fault, what to do? Fault Cause Remedial action Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. detergent dispenser or in therefore detergent is not rinsed the tablet collecting tray. out. The detergent dispenser was Pour detergent into the dry detergent damp when filled.
Customer service Customer service Installation and connection C u s to m e r s e r v i c e If you are unable to rectify the fault, In s ta l la t io n a n d c o n n e c t io n please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Drinking water connection Warm water connection * W a r m w a t e r c o n n e c t i o n 1. Fasten the drinking water connection * depending on model to the tap according The dishwasher can be connected to the installation instructions using to cold or hot water up to max.
Installation and connection Electrical connection Transportation Connect the appliance only to 110 V Empty the dishwasher and secure loose ■ and 60 Hz alternating current via parts. a correctly installed socket with Drain the appliance according to the protective conductor. See rating following steps: plate for required fusing 92.
Page 42
*9001431514* 9001431514 en (9812) 440MA...
Need help?
Do you have a question about the SPS63M02TC and is the answer not in the manual?
Questions and answers