Advertisement
ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping of the drawer, the Anti-Tip block must
be properly installed located 14
Sharp Microwave Drawer
™
must be provided by the installer. See Figure 1. The Anti-Tip block
prevents serious injury that might result from spilled hot liquids.
If the Sharp Microwave Drawer
different location, the Anti-Tip block must also be moved and
installed. When installed to the wall, ensure the screws completely
penetrate the drywall and are secured in wood or metal so the
block is totally stable. When fastening, ensure the screws do not
penetrate electrical wiring or plumbing.
ELECTRICAL OUTLET
The electrical requirements are a 120 volt 60 Hz, AC only, 15
amp. or more protected electrical supply. It is recommended that
a separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug. It must be
plugged into a properly installed and grounded wall receptacle.
Should you only have a 2-prong outlet, have a qualified electrician
install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or serviceperson.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach.
Always check electrical codes for requirements.
/
" above the floor on which the
13
16
Oven will sit. The 6" Anti-Tip block
Oven is ever moved to a
™
Figure 8
Figure 9
GROUNDING INSTRUCTIONS
This appliance must be grounded. The Sharp Microwave Drawer
Oven is equipped with a cord having a grounding wire with a
grounding plug. It must be plugged into a properly installed and
grounded wall receptacle in accordance with the National
Electrical Code and local codes and ordinances. In the event of
an electrical short circuit, grounding reduces risk of electric shock
by providing an escape wire for the electric current.
Improper use of the grounding plug can result in
WARNING
a risk of electric shock. Do not use an extension cord. If the
power supply cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
DRAWER INSTALLATION
1. Place the drawer adjacent to the wall or cabinet opening. Plug
the power supply cord into the electrical outlet.
2. Carefully guide the drawer into the prepared opening. Avoid
pinching the cord between the oven and the wall.
3. Slide the drawer all the way until the mounting flange is flush
with the face of the cabinet. See Figure 10.
4. Open the drawer. Using the 4 holes on the drawer as a template,
pre-drill the cabinet using a
5. Secure the drawer with the 4 screws supplied. See Figure 11.
Parts supplied - 4 Screws
5
Grounded receptacle box
Screw
/
" bit. See Figure 10.
1
16
Side
Rail
Figure 10
Figure 11
™
Grounding adapter
Tab for grounding screw
E
Advertisement
