Toshiba 14SV2M Service Manual page 16

Note:
• When "SKIP" is ON, the Position number is
prefixed by "*".
Example: *13. To confirm this, select Position
13 using the -/-- and 0~9 buttons.
• If you want to restore a skipped position
number, select it using the -/-- and 0~9
buttons then switch the "SKIP" setting to
"OFF" as in step 2 above.
Manual fine tuning (MFT)
Under some reception conditions, fine
tuning may be necessary to improve the
picture quality. In such cases, adjust the
manual fine tuning (MFT).
1 Press MENU and ; –/+ to call up the
"TUNING" menu D8 .
2 Press CH s/t and select "MFT". Press ; –/+
to start fine tuning. Pressing "-" fine tunes
to a lower frequency while pressing "+"
fine tunes to a higher frequency.
Auto fine tuning (AFT)
If the signal frequency is unstable due
to environmental conditions, use auto
fine tuning.
1 Press MENU and ; –/+ to call up the
"TUNING" menu D8 .
2 Press CHs/t and select "AFT". Press ; –/+
to switch it to "ON". This completes the
setting.
Notes:
• When you operate MFT, AFT is switched
OFF automatically. If you switch on AFT
after fine tuning with MFT, MFT may be
cancelled.
• AFT may be set independently for each
Position.
– 16 –